High quality compression fitting for MDPE pipe. 25mm MDPE to ¾" BSP female thread. Suitable for use below ground on cold water services. All fittings have a co-polymer polypropylene body, nut and thrust ring, acetal grab ring and nitrile seal. High impact resistant body and nut enables absorption of thermal and mechanical stress. Excellent pressure resistance, tested to 48bar. Simple and quick to connect - no need to dismantle the connecter nor chamfer the pipe, just cut the pipe, lubricate the seal, undo the nut a few turns, insert the pipe liner/insert, push the pipe in as far as it will go, tighten the nut and its done! Comfortably exceeds the performance requirements of UK Water Bylaws Scheme. MDPE Fittings are WRAS approved, certificate number 0507060.
Average Customer Rating:
(2 Reviews) 2
Rating Snapshot(2 reviews)
2 of 2(100%)reviewers would recommend this product.
Customer Reviews for FloPlast MDPE Female Adaptor 25mm x ¾"
Review 1 for FloPlast MDPE Female Adaptor 25mm x ¾"
"What can I really say about a simple adaptor like this - I bought it to connect 25mm MDPE pipe to a 3/4" male thread on an expansion vessel for my irrigation system, it does the job, was inexpensive, and most importantly was actually in stock when I wanted it!."
Share this Review:
Review 2 for FloPlast MDPE Female Adaptor 25mm x ¾"
"Solid product but I found real care was required when screwing brass BSP into the plastic of the female socket. Plenty of PTFE tape required to get a pressure-tight joint, but easy to cross-thread if too much was used."