Made from polypropylene, this is a quick and easy way to install waste systems incorporating a push-fit ring seal system. An allowance of a 10mm expansion gap on all push-fit joints is required for the expansion of pipes and fittings in each socket of push-fit systems. Requires no solvent welding or tightening. Manufactured to BS EN 1451-1: 2000 / BS 5254.
Average Customer Rating:
(4 Reviews) 4
Rating Snapshot(4 reviews)
4 of 4(100%)reviewers would recommend this product.
"A good product for a nice quick installation. Simple to use and anyone can install with minimum fuss. As a plumber I prefer solvent weld when I'm installing from new because push fit joints can pull apart with age, especially if the pipework is not properly supported. However, I always carry some push fit waste for amending existing push fit waste systems and just make sure the pipework is securely clipped so the joints are supported."