Manufactured from high temperature white polypropylene with compression type outlets that fit plastic pipes to BS 5254 and BS 5255 and copper pipes to BS 659 and BS 2871. Suitable for use in most ground floor situations where the discharge waste pipe is going direct to a gully. 38mm seal makes fitting easier when the floor is made of concrete. Easy access for cleaning. Manufactured to BS EN 274.
Average Customer Rating:
(19 Reviews) 18
Rating Snapshot(19 reviews)
14 of 19(74%)reviewers would recommend this product.
"This shallow device saved a lot of work.I wanted to reverse the orientation of my new bath, but a normal trap would have meant having to go below floorboards and cut a number of joists.This device allowed the waste to fit without that need.It seems to empty bath just as good as a normal trap."
"Its a bit limited what can be said about this but its good quality at a reasonable price . It fits into very limited space and as it is tight to the bath it allows a decent fall in the drain run. It also has the advantage of a extra unscrewable bit in the U for cleaning if required without having to remove the whole thing."
"Easy to use good value for money,definatly the cheapest in price cheaper than my local merchant good quality.Connects straight onto bath waste one end and commpression the other end onto waste pipe 40mm/1 1/2""
"Great low profile product. I almost returned back as it looked like it would be too big and touch the floor when you test it on the waste. But if you actually screw it all the way on the waste it fits on a standard cast iron free standing bath with a few mm to spare."
"This trap represents reasonable quality at an exceptional price. The one caution I would say is to make absolutely sure that the service port of the trap is sealed properly before use. Mine had obviously just been loose assembled in the factory and leaked badly on first test. I had to take the service port blanking plug off and carefully push down the rubber seal to get it fully seated squarely in the back of the plug, before screwing it back onto the trap firmly. Then all was well."
"Although I fitted everything and double check the connections it started to leak from the small access point. I had hand tightened it and so i tightened it a little more but it kept on leaking!! I checked the seal and everything but it was useless. Chucked it in the bin for something more reliable!"
"Cheap but useless. Stripped the threads before it was hand tight. I thought it may have been me that cross threaded it so i bought another; same outcome. Leaks like a sieve and stupidly simple to cross thread.
"The shallow design is great to avoid chopping floorboards, but I had two problems with this part- the seal to the bath leaked as it is too narrow and didn't seal correctly, and the access port cover also wouldn't seal even when carefully tightened. Next time I would happily spend a bit more for a better quality part."