Adjustable 0-90°. Polypropylene. Not suitable for solvent welding. Push-fit joint through an innovatively designed seal and snap-cap system. The use of silicone lubricant on all seals will facilitate jointing.
Average Customer Rating:
(10 Reviews) 10
Rating Snapshot(10 reviews)
10 of 10(100%)reviewers would recommend this product.
"This is such a great product! I used this bend when trying to connect a new 110mm plastic to an existing waste pipe that was a combination of vertical and horizontal angles, neither of which were 45 and 90 degrees. Easy to fit and worked very well."
"I bought one of these to repair a damaged septic tank outlet. It made a potentially difficult job very easy, Because the bend is infinitely adjustable there is no strain on the connections making installation so much easier, you just make everything up, let it find its own position and then tighten the locking rings."
"I used this when replacing some collaped ceramic drains and wasnt sure how plastic would lie in comparison to ceramic. Instead of getting several different bends I just brought this one. Plastic did lie slightly differently but this bend made a perfect fit and line. Dont forget to loosen the collars before fitting & then to tighten up once in situ"
"Somewhat difficult to get to grips with this item,but once mastered no proplem. I would rather have used a standard bend,but needs must when in a confined space.Looks a bit clumsy but does work It's ingenious how it works.."