"I use these boxes everywhere I can on both Lighting and power circuits. Look smart, easy to use. They increase the flexibility of a circuit wherever a hardwired item needs to be connected (and may need replacing), and greatly facilitate extending or changing a circuit at a later date"
"Used to connect 4mm SWA and coped with ease- plenty of room and you can move the connecting bar to different positions in box to suit your needs. Be aware that only one side has a middle knockout, the other 3 all have 2 knockouts so cable entry / exit will be offset from middle of box on these 3 sides"
"Well, what can one say about an IP65 junction box? It works perfectly for most jobs, ports are easily removed for access and fits connectors easily.
My only complaint would be the two unsealed holes on the back. They may seal when using the connector inside however I was using it to connect 2 6mm cables hence the 2 holes. The downside now is if it's a wet environment you're putting it in, just be aware of these holes as you may find it gets a little damp inside.
"Good value for money, however it does have its limitations, would not use for anything above 24V. My main problem was with the cable entry locations, the rubber seal around the area was to large to accept a good fit with a 20mm conduit coupling."
"Wanted a IP65 plastic box with plain sides so I could drill TWO holes in the bottom side. Could not get this off stock so had to get larger size with two pre-selected holes on each side. IT HAD TO DO TO FINISH THE JOB.."