Made from polypropylene, this is a quick and easy way to install waste systems incorporating a push-fit ring seal system. Fits most standard size waste pipes (excluding solvent weld waste). An allowance of a 10mm expansion gap on all push-fit joints is required for the expansion of pipes and fittings in each socket of push-fit systems. Requires no solvent welding or tightening. Manufactured to BS EN 1451-1: 2000 / BS 5254.
Average Customer Rating:
(10 Reviews) 10
Rating Snapshot(10 reviews)
9 of 10(90%)reviewers would recommend this product.
"Only a good fit on flo-plast pipe. Very loose fitting or not at all on other push fit pipes. Marley was fine on all pipes in comparrison. It's good value if buying all flo-plast for a new installation but very annoying when you need to make another trip out because this didn't fit."