Black. Quick to install - pipe can be added after clips are in place. Only one screw hole needed. Compatible with most major manufacturers. Cost effective solution for both new build and refurbishment applications. Kitemarked KM501316.
Average Customer Rating:
(4 Reviews) 4
Rating Snapshot(4 reviews)
2 of 4(50%)reviewers would recommend this product.
Customer Reviews for Half Round Easyfit Clips 68mm Pack of 10
Review 1 for Half Round Easyfit Clips 68mm Pack of 10
"Most pipe clips fix on two drill holes and support the pipe from three sides. Here's one that is a bit stonger and fixes faster, using a single fixing hole. The securing band locates on a moulded key-way, after it and the pipe has been mounted. The key way locks the band in place and the result is a band that holds the pipe, all the way round, more securely than the two legged type and less susceptible to fracture. Of course, it is still plastic and will not last as well as cast iron supports and pipes but it is a tenth the price and light, simple and stays looking good for about ten years."
6 of 6 people found this review helpful.
Share this Review:
Review 3 for Half Round Easyfit Clips 68mm Pack of 10
"the construction of these seems totally fine for the price paid and no doubt they will last well enough - however they don't hold the pipe. (purchased from the same screwfix range so they really should fit) it just slips out as the clip is too large for the circumference of the downpipe. + the downpipes themselves also slip out of each other..have been propping it up on the water barrel but need to use some kind of sealant/wedge to get it to all hold together! which is kinda ridiculous really.."
1 of 1 people found this review helpful.
Share this Review:
Review 4 for Half Round Easyfit Clips 68mm Pack of 10
"Had some tricky guttering to fit and only having to make one hole seemed like a good idea. So easy to fit, all lined up and then clip clip clip and then the brackets did not hold the pipe. Its probably the old imperial v metric problem but I ended up topping and tailing with the two hole units to get control over the pipe. Would use these again (as they are now in the stock pile) but will check that they hold the pipe well before fitting them."