Top Rated Product

Product Reviews

8 × 80 S/S Hammer

8 × 80 S/S Hammer
Average Customer Rating:
5 out of 5
5
 out of 
5
(2 Reviews) 2
Open Ratings Snapshot
Rating Breakdown 2 reviews
5 stars
2
4 stars
0
3 stars
0
2 stars
0
1 star
0
2 of 2(100%)reviewers would recommend this product.
Customer Reviews for Fischer Stainless Steel Hammer Fixings x 80mm Pack of 10
Review 1 for Fischer Stainless Steel Hammer Fixings x 80mm Pack of 10
Overall Rating: 
5 out of 5
5 out of 5
Value: 
5 out of 5
5 out of 5
Features: 
5 out of 5
5 out of 5
Performance: 
5 out of 5
5 out of 5
Reliability: 
5 out of 5
5 out of 5
Would you recommend this product? Yes
Overall Rating: 
5 out of 5
5 out of 5
Value: 
5 out of 5
5 out of 5
Features: 
5 out of 5
5 out of 5
Performance: 
5 out of 5
5 out of 5
Reliability: 
5 out of 5
5 out of 5
Did the Job perfectly
04-Oct-2014
By
, Luton
"Needed fix for my Garage rear door frame, which was moving slightly. These screws with fixings were easy to put in. Just select correct drill, push in tight, then screw. Job done. Perfect"
Review 2 for Fischer Stainless Steel Hammer Fixings x 80mm Pack of 10
Overall Rating: 
5 out of 5
5 out of 5
Value: 
4 out of 5
4 out of 5
Features: 
5 out of 5
5 out of 5
Performance: 
5 out of 5
5 out of 5
Reliability: 
5 out of 5
5 out of 5
Would you recommend this product? Yes
Overall Rating: 
5 out of 5
5 out of 5
Value: 
4 out of 5
4 out of 5
Features: 
5 out of 5
5 out of 5
Performance: 
5 out of 5
5 out of 5
Reliability: 
5 out of 5
5 out of 5
Fast and Secure
24-Nov-2012
By
, Locks Heath
"I used these to mount heavy wooden battens to new brickwork (taking care not to drill into the "frog" section of the brick).
Using 8mm holes in the battens as a guide for drilling the brick, fitting was completely trouble-free, and quickly produced a very secure fixing.
The nylon inserts were a loose fit in the hole (I used a new 8mm DeWalt Extreme 2 masonry bit) and it was only possible to tighten them, at least initially, by hammering. Experiments at using a screwdriver simply resulted in the insert turning in the hole."