Cuts up to 100mm thread into concrete, brick and hollow block. Removable, adjustable and reusable. No need for plugs or pre-marking. Reversed hi-lo thread and blue climaseal finish. Use close to edges and approved for pre-cast hollow pot beams. For easy installation use the Masonry Condrive Kit (Code 29747).
Average Customer Rating:
(2 Reviews) 2
Rating Snapshot(2 reviews)
0 of 2(0%)reviewers would recommend this product.
Customer Reviews for Tapcon SDS+ Masonry Drill Bit 5 x 180mm Pack of
Review 1 for Tapcon SDS+ Masonry Drill Bit 5 x 180mm Pack of
"Needing to fix timber battens to the gable wall of a stone house, I decided to use Tapcon screws, and therefore bought 2 tapcon drillbits to drill the holes. Normally when I buy masonry drillbits they last for months, wearing the drill shank down before the hardened tip. These completely rubbish drills lasted 20 holes. In my opinion they are not fit for purpose and shouldn't be sold. I read the other review that told a similar tale, but didn't actually believe they could be as bad as the guy said. Believe me they are."
7 of 7 people found this review helpful.
Share this Review:
Review 2 for Tapcon SDS+ Masonry Drill Bit 5 x 180mm Pack of