"This hose makes fitting taps really easy. It flexible, has the tap connect end which only needs to be hand tight plus a little extra turn as rubber seal inside does the trick. Also on this product it has double end 1/2 inch connector so can connect straight to a compression tread or to the end of an ISO valve. No additional pipe required. Product can also come in different lengths and a combination of ends to suit every type of situation. Makes my life so much easier."
"All easy to assemble by a non-plumber. Does the job, no leaks (applied a sealant paste also from Screwfix). I cannot comment on reliability after only a few days have past since fitting it with my tap."
"A difficult job made easy: some nasty leaking taps on a bath with very poor access so copper piping was out of the question. These braided flexible hoses came to the rescue and proved just the ticket - easy to fit and flexible enough to work into the limited space available. It's just a pity they'll be behind the bath side panel as they look good as well!"
"why mess around with a blow torch and fittings under a sink i say--so much easier especially when you have arthritis!! it just makes the job so much easier and no wondering if you will have a leak at your soldered joints"
"I needed a 3/4" but screwfix only sell 1/2" still did the job, the hose does flatten when bent, but with a bit of moulding with your fingers and spinning of the hose you can get rid of the pinch points in the bends."
"unlike most, this has the same connections at both end and solved my problem of replacing the old rigid copper pipe between the stop valve and the fill valve on my cistern. I wish I had spotted this sooner! It has just been installed so long term performance cannot be judged"