"I was faced with a tricky challenge converting a downstairs WC into a temporary utility room. I wanted to avoid major redesign of the drainage system and knew exactly what I needed, but wasn't sure if such a thing existed. A quick visit to Screwfix, swift thumb through the catalogue and there it was! Easy to fit (with a bit of care cutting the correct size hole for the P-trap pipe) and works brilliantly - a neat, quick, versatile and inexpensive solution - thanks Screwfix!"
"I was faced with a collection of pipes all just mortared into an outlet. This fitting just made it so much easier to tidy the whole job up, neatly and watertight (just carefully cut to the hole size you need for a tight fit). Job sorted and must be more efficient than cement mortar from the 1970's !"
"This has always been a great product, good tight fit but easy to install. It must be installed in the pipe and not a plain boss, without the pipe it will fit very loosly and won't seal at all. The best way to cut the rubber flange is with a sharp pair of scissors in the top flat and then cut round carefully to open up to the required size, cut out as little as possible to ensure a good tight fit."
"This is a highly flexable rubber insert so does not fit over the 100mm pipe but fits inside. It makes a good seal and the universal waste cut out is great but it takes some cutting as the rubber is of great quality!"
"Screwfix very unhelpfully don't give an adequate description. This product is only big enough to fit into a 110mm pipe - it is too small for a 1l0mm socket. A fairly crucial distinction when I bought it for a socket."
"I use these Universal Waste Adaptors when I remove a toilet, to temporarily seal off the socket that the pan connector goes into. With the w/c u-bend removed, these stop the smells coming into the room whilst working there - much improved aroma!"