"This fan has a very slim profile and looks good. I selected 'fast speed' with the small 'dip switches' - after reading instructiions. Not too noisey in operation. I left the factory set time which gives about 15 minutes run-on (can be adjusted to shorter time if wanted). Only one small issue to watch out for in my opinion: The cable terminals are very small and the cable entry needs to be near upper right corner when looking on front of fan. I used 3-core 0.75mm2 round flexible cable. Fan is double insulated, so only needs L, N and L (switched) wires i.e. No Earth! Connection diagram supplied was not particularly good as it mismatched against the fan terminal labels! In use, I like the fan, it does it's job well and is very efficient considering it's low ellectrical consumption. Only a couple of months since I installed, so can't advise on long term reliability."
6 of 6 people found this review helpful.
Share this Review:
Review 3 for Vent-Axia LoCarbon Silhouette 100T Axial Bathroom Extractor Fan with Timer
"Used this fan in a small bathroom as a replacement. Looks good with a low profile on the wall. On the lower setting the fan is almost silent but put it to the higher setting for removing steam - with an overun of about 10 mins. The lower setting would be ideal for cloakrooms and the power consumption is minimal. I have given 4 for reliability because I do not know yet how long it will last."
8 of 8 people found this review helpful.
Share this Review:
Review 4 for Vent-Axia LoCarbon Silhouette 100T Axial Bathroom Extractor Fan with Timer
"Overall rating given only as good as this fan was bought to replace an existing vent axia fan of the same part number and the hole for the cable and the connection block was 180 degrees different to the existing one. Reliability unknown at this point as it has only been in operation for two day's, but if it is good as the last one, 14 years of service."