Product Reviews

LAP 20A DP Switch & Neon

LAP 20A DP Switch & Neon
Average Customer Rating:
1.5 out of 5
1.5
 out of 
5
Open Ratings Snapshot
Rating Breakdown 2 reviews
5 stars
0
4 stars
0
3 stars
0
2 stars
1
1 star
1
0 of 2(0%)reviewers would recommend this product.
Customer Reviews for LAP 20A DP Switch with Neon Stainless Steel
Review 1 for LAP 20A DP Switch with Neon Stainless Steel
Overall Rating: 
2 out of 5
2 out of 5
Value: 
4 out of 5
4 out of 5
Features: 
3 out of 5
3 out of 5
Performance: 
1 out of 5
1 out of 5
Reliability: 
2 out of 5
2 out of 5
Would you recommend this product? No
Overall Rating: 
2 out of 5
2 out of 5
Value: 
4 out of 5
4 out of 5
Features: 
3 out of 5
3 out of 5
Performance: 
1 out of 5
1 out of 5
Reliability: 
2 out of 5
2 out of 5
Screw terminals too small.
9 May 2012
By russ50
, Merseyside
" For a 20amp switch that requires termination of 2.5mm wires in the terminals, the screw sizes were small and poor. The same make sockets were fine (also needing 2.5mm) and also the 13amp switched fused spur but the 20amp switch had smaller terminals and screws. This proved difficult as 3x2.5mm cables had to be crammed into each input terminal (not sure if they will stay tight). The switch itself also had a poor feel (not positive click when switched). "
2 of 2 people found this review helpful.
Review 2 for LAP 20A DP Switch with Neon Stainless Steel
Overall Rating: 
1 out of 5
1 out of 5
Value: 
1 out of 5
1 out of 5
Features: 
1 out of 5
1 out of 5
Performance: 
1 out of 5
1 out of 5
Reliability: 
1 out of 5
1 out of 5
Would you recommend this product? No
Overall Rating: 
1 out of 5
1 out of 5
Value: 
1 out of 5
1 out of 5
Features: 
1 out of 5
1 out of 5
Performance: 
1 out of 5
1 out of 5
Reliability: 
1 out of 5
1 out of 5
avoid these switches
12 Dec 2013
By beigeb
, Jedburgh
" The LAP sockets were of good quality but the terminals on the 20 DP switches for tightening up two 2.5 cables was of poor standard. I installed these on a kitchen job recently and had issues with all 3 switches - decision will be whether to change everything or try some new switches that I dont rate???? "