"Customers of mine decided to tile the area around the shower pipes before I got to them so I was left with two pipe ends inside a cavity and two of these little beauties purchased from Evesham Screwfix did the job perfectly. I fitted them to one end of the horizontal pipe, placed them above the pipe ends and just pushed them down. The 'Shark' teeth hold the fitting in place well and they also allow for some 'swivel' of the joint as well. I now keep 6 of these on my van for just this type of situation."
"I have used these products several times, They are very easy, just use a pipe cutter for the rounded edge and the pipe slots in perfectly, well engineered product. Well done and thank you to the designer."
"2 problems with these connectors- 1 - they restrict the flow - I wanted 22mm elbow, but the body of the connector is narrow, about 15mm, no good for a shower feed using 22mm pipework. 2 - they are NOT rigid when connected - a solder ring type connector gives a strong joint with strength, these joints wobble. On the plus side, they don't leak and are very easy to use."