Product Reviews

Installs easily where access is limited. Fits most standard size waste pipe (excluding universal push fit waste). Requires no tightening. A lightweight yet strong and cost-effective option. Apply solvent cement evenly to both surfaces of joint, insert pipe fully into the socket depth and remove surplus cement with a cloth. Allow five minutes to set before handling and twelve hours before testing the system. It is recommended that externally installed ABS waste systems are protected against prolonged exposure to sunlight with exterior gloss paint.

Installs easily where access is limited. Fits most standard size waste pipe (excluding universal push fit waste). Requires no tightening. A lightweight yet strong and cost-effective option. Apply solvent cement evenly to both surfaces of joint, insert pipe fully into the socket depth and remove surplus cement with a cloth. Allow five minutes to set before handling and twelve hours before testing the system. It is recommended that externally installed ABS waste systems are protected against prolonged exposure to sunlight with exterior gloss paint.
Average Customer Rating:
3 out of 5
3
 out of 
5
(2 Reviews) 2
Open Ratings Snapshot
Rating Snapshot (2 reviews)
5 stars
1
4 stars
0
3 stars
0
2 stars
0
1 star
1
1 of 2(50%)reviewers would recommend this product.
Customer Reviews for FloPlast 92.5º (87.5°) Bend White 32mm Pack of 5
Review 1 for FloPlast 92.5º (87.5°) Bend White 32mm Pack of 5
Overall Rating: 
5 out of 5
5 out of 5
Value: 
5 out of 5
5 out of 5
Features: 
5 out of 5
5 out of 5
Performance: 
5 out of 5
5 out of 5
Reliability: 
5 out of 5
5 out of 5
Would you recommend this product? Yes
Overall Rating: 
5 out of 5
5 out of 5
Value: 
5 out of 5
5 out of 5
Features: 
5 out of 5
5 out of 5
Performance: 
5 out of 5
5 out of 5
Reliability: 
5 out of 5
5 out of 5
Great solvent fittings
12 Mar 2013
By Lefty14
, Banbury
"I have been using these fittings for years, make sure you use solvent weld pipe and they do the job. Alot better & secure than push fit waste systems."
Review 2 for FloPlast 92.5º (87.5°) Bend White 32mm Pack of 5
Overall Rating: 
1 out of 5
1 out of 5
Value: 
1 out of 5
1 out of 5
Features: 
1 out of 5
1 out of 5
Performance: 
1 out of 5
1 out of 5
Reliability: 
1 out of 5
1 out of 5
Would you recommend this product? No
Overall Rating: 
1 out of 5
1 out of 5
Value: 
1 out of 5
1 out of 5
Features: 
1 out of 5
1 out of 5
Performance: 
1 out of 5
1 out of 5
Reliability: 
1 out of 5
1 out of 5
too tight
20 Nov 2012
By hammy71
, kettering
"All 32mm flo plast solvent weld fittings are too tight, 40mm are fine. I have found with all 32mm fitting to make life a bit easier to use a wire brush in a drill to loosen them off a bit"
1 of 2 people found this review helpful.