Product Reviews

Carron Phoenix Inset Sink

Carron Phoenix Inset Sink
Average Customer Rating:
3.5 out of 5
3.5
 out of 
5
Open Ratings Snapshot
Rating Breakdown 2 reviews
5 stars
0
4 stars
1
3 stars
1
2 stars
0
1 star
0
2 of 2(100%)reviewers would recommend this product.
Customer Questions & Answers:
1 Question | 0 Answers
Customer Reviews for Carron Phoenix Kitchen Sink S/Steel 1 Bowl LH 940 x 485mm
Review 1 for Carron Phoenix Kitchen Sink S/Steel 1 Bowl LH 940 x 485mm
Overall Rating: 
4 out of 5
4 out of 5
Value: 
5 out of 5
5 out of 5
Features: 
4 out of 5
4 out of 5
Performance: 
4 out of 5
4 out of 5
Reliability: 
4 out of 5
4 out of 5
Would you recommend this product? Yes
Overall Rating: 
4 out of 5
4 out of 5
Value: 
5 out of 5
5 out of 5
Features: 
4 out of 5
4 out of 5
Performance: 
4 out of 5
4 out of 5
Reliability: 
4 out of 5
4 out of 5
Excellent value for money
24 Jul 2014
By minoru
, York
" Very good value and easy to install. Waste fittings especially good. Would recommend as mid range sink new or replacement . "
6 of 6 people found this review helpful.
Review 2 for Carron Phoenix Kitchen Sink S/Steel 1 Bowl LH 940 x 485mm
Overall Rating: 
3 out of 5
3 out of 5
Value: 
4 out of 5
4 out of 5
Features: 
3 out of 5
3 out of 5
Performance: 
3 out of 5
3 out of 5
Reliability: 
4 out of 5
4 out of 5
Would you recommend this product? Yes
Overall Rating: 
3 out of 5
3 out of 5
Value: 
4 out of 5
4 out of 5
Features: 
3 out of 5
3 out of 5
Performance: 
3 out of 5
3 out of 5
Reliability: 
4 out of 5
4 out of 5
Good but edges bowed.
25 Feb 2015
By Anonymous
, Derby
" Bought this sink for my utility room. I was prepared to pay a bit more for a known brand than for the "contract" products. Arrived well packed with good instructions.
Overall a good sink with one potentially big weakness in that as part of the manufacturing process it is not flat around the edge, particularly the short edge next to the bowl which is concave (ie opposite to the sink dishing) by 3-4mm. This is pulled out during installation by tightening the fixing clips but the one next to the sink was distorting and slipping before enough of the dishing was pulled out.
I used tape and silicon sealant to seal the edge but I think it was a close run thing.
FTR I trimmed the cut out in the worktop to absolute accuracy with a router. "
2 of 2 people found this review helpful.