"Easy to fit with 2 fixing nuts which is always better than 1 because less likely to loosen over time. Supplied with pop up waste but you don`t have to use it and i`ve found them to cause problems after a while so prefer separate pop up or good old fashion plugs.As with all mono taps you will need a set of deep mono tap sockets unless the sink is not fitted."
"This is a good value tap. Cheaper to replace with this tap than buy the inserts for the more expensive mixers. Lasts very well in a commercial environment. We've been using them for about two years and not had to replace one yet."
"Good replacement mono tap & waste unit for bathroom sink. Watch out for low pressure system on your hot water,. My tank is about 3 metres above the tap outlet and works but it is on the limit, a metre lower and I think I may have been in trouble. Instructions are fair. However, a bit of expertise is needed fitting the tap. One important point you may need a 6 to 7 mm box spanner to tighten up the tap fixings. A socket spanner will not go over the screw extension unless this is cut short. Purchasing/borrowing the box spanner for the job will save hours of time and a lot of cursing."
"Taps are great to install, but the waste will NOT fit the Mon rectangular sink #64987!! Found this out the hard way, so couldn't use the pop-up element. The thread is not long enough to reach through the base of the sink....."