"Bought this for a client. No problems fitting it. Being only 150W it will take longer to heat up, so if you need something to heat up quickly go for a higher watts (400?) or if you what to leave this on for longer it's ideal to save £££."
"Hard to see how the previous reviewer couldn't get this to seal. It has an 'O' ring which (if it isn't overtightened) should give a reliable seal with no need for any PTFE tape or other sealant. Easy to fit and for me150W gives enough heat in a 500 wide x 1000 tall flat towel rail without running up too big an electricity bill!"
"The Tee-piece was fine, but the element's thread was rough and the burrs needed filing off to enable it to screw freely/fully into place. The o-ring was then able to seal properly. The built-in thermostat seems to be opening 'early' at <60C when fed by a Dimplex controller on max-but ok so far on reduced setting but not as warm as original. Makers Tesla have been informed."
"3 times we tried to fit one of these and all 3 failed - none of them worked and the quality checking on these must be pretty bad for that to happen. Now gone to another manufacturer/seller to try another make!"
"Fitted with new towel rail and failed after 12 hours, replaced without fuss by screwfix and the second one failed again inside 12 hours. 3 fits and travelling expenses along with an unhappy customer makes this product a no no. I would like to say screwfix were very helpful and refunded without any hassle."