"Although I have rated this product highly, it is my opinion that if only one size of 10mm dowel is to be stocked, it should be longer than 40mm. Where a flush cut dowel end is required, the effective length of this item is actually less than 40mm due to the taper. I should have realised this when I bought them. I would suggest that a minimum length for this diameter should be 50mm. Having said this, I find no fault with the actual item."
Share this Review:
Review 2 for Precision Multi-Grooved Dowel Pins 10 x 40mm Pack of 100
A bit undersize when inserted into a hole drilled in MDF using Screwfix's "Erbauer" brad point bits.
I think it's a dowel problem, not a hole size problem as other bits also produced holes that were slightly too large. The dowels don't seem to be sufficiently compressed to enlarge with moisture in the same way that biscuits do.
If it's of any help, I don't think other makers' dowels are ant better."