T20 Star Drive. Zinc and yellow-passivated. Single thread. Countersunk head. Patented ground serrations for quick penetration. For all tongue and groove flooring including hard and softwoods and fibreboards. Requires no pilot hole or pre-drilling. Supplied in a handy tub. Tested to ETA-12/0114.
Average Customer Rating:
(6 Reviews) 6
Rating Snapshot(6 reviews)
5 of 6(83%)reviewers would recommend this product.
Customer Reviews for Spax Flooring Screw Zinc & Yellow Passivated 4.5 X 60mm Pack of 300
Review 1 for Spax Flooring Screw Zinc & Yellow Passivated 4.5 X 60mm Pack of 300
"As an alternative to nails and common screws, this design is superior in that any gap between board and joist is closed. The T20 drive takes a little getting used to (compared to PZ2) because the bit doesn't drop in to the head as naturally. I always drill a clearance hole in the board. A stainless version may look nice if left exposed?"
2 of 2 people found this review helpful.
Share this Review:
Review 5 for Spax Flooring Screw Zinc & Yellow Passivated 4.5 X 60mm Pack of 300
"Item was not with threads at top & bottom as illustrated so I returned item immediatley - screws with a thread only at the bottom end - well - I have tons of these so that was the whole point of ordering!"
1 of 2 people found this review helpful.
Share this Review:
Review 6 for Spax Flooring Screw Zinc & Yellow Passivated 4.5 X 60mm Pack of 300
"Theses are nice screws and having the star drive makes for an easy drive with no risk of mashing the heads.
BUT ... I did find its easy to drive them in too far ... the countersunk heads need to be bigger. They will drive straight through 25mm ply if your not careful with torque settings, and I felt they were not giving a solid 'clamp' to the joists as using conventional Goldscrews which have much bigger heads on them.
All said and done ... they are nice to use, and wont go to waste on other applications ... I wish all screws had a star drive!!"