"AMAZING VALUE. its a decent quality well made light, real metal, real glass and looks great installed. the glass diffuser does well to disperse the light, but does take a lot of the light away. this is the same for all lights of this type though really, I prefer to go for the 2D flourescent fittings personally, but hey, the customer is always right,"
"I have now purchased two of these to replace older fittings in a bathroom and a toilet. They are simple to fit, provide good light and look good. They operate on a standard ES bulb fitting, I use energy saving bulbs that provide ample light."
"Great value, functional bathroom light. We had our electrician replace 4 ugly recessed downlighters with these units. It allows us to get rid of the recessed fittings and improve the loft insulation above.
Great diffused light, modern looking and good value for money."
"Decent product for the price. Only things i would complain about are the size of the hole for the incoming cable, which could be bigger. It only seemed big enough to fit a 1.5mm twin & earth flex. 25mm hole would be nicer. The diffuser seemed to block a lot of the light. The cables are also connected via push-fit, connector block would have been much easier."
"OK for an IP44 light this is cheap. The downside is there are no internal connections for looping the switch or an extractor fan (I know the latest regs require an isolator, but this does not need to be changed if it is simply a fitting swap), so you have to lose the ceiling rose in the ceiling space above and run a heat proof flex down to the light. The other problem is that the knurled retaining nuts for the cover have silicone washers (for the IP44 rating I presume) between them and the bezel, it's quite tricky to hold all the bits in place whilst you do them up, finally resolved by supergluing the silicone washers to the bezel. Other than that it's a good light. If you are using energy saving bulbs, get one of larger wattage than you would expect to use as the diffuser seems to soak up a lot of the output"
"Cheap get what you pay for fitting. Cable entry to small for loop & switch cables, have to use additional connector block for loop in loop out, has fiddly push in terminals in lamp holder, HAD TO RETURN ITEM FOR EXCHANGE AS A TERMINAL CONNECTOR IN LAMP HOLDER WAS MISSING !!!!"
"Don't buy this fitting it is very poor quality! The terminals are push fit and came out when I tried to insert the cable. all plastic fittings in side and the holder made poor contact with the lamp again this is due to the lack of quality in the push fit terminal.
Had to remove diffuser a couple of times this was not easy as the nuts that hold it in place are very small and have a loose silicone washer behind them, you need 3 hands to fit it easily. The nuts and washers are so small they are easy to drop and lose as I have done :-( not impressed! This makes the lamp expensive at £15.99"