1-way DP with neon and mechanical indicator. Integral pattress for surface mounting. Can be mounted to a large circular conduit box. Complies with BS 7671 for use as an isolating device. Terminals will accept up to 10mm² cable. Standard pull cord is 1.5m long, in white. For use with 25mm x 16mm trunking. Rated for non-inductive loads only.
Average Customer Rating:
(17 Reviews) 17
Rating Snapshot(17 reviews)
17 of 17(100%)reviewers would recommend this product.
Customer Reviews for Crabtree 50A Pull Cord Switch + Neon
"Easy to fit, works well and very reliable. Takes 10mm cable without problems. Only SLIGHT niggle is that screws to fix cable are at an angle so if you fit too close to wall you cannot get a straight screwdriver in to tighten them.."
"Seems much more robust than the cheap (half the price) switch it replaced (also from Screwfix). That one lasted under 4 months (to be fair, Screwfix gave me a full refund). The switch mechanism is so much more positive. Very easy to fit. Only gave it 3 stars for reliability as it's too early to tell but I'm hoping it'll last a lot longer than 4 months."
"If you're using 10mm cable for a 9.5kW+ shower this is by far the easiest to fit. Best way is to terminate the cable into the fitting, then screw it to the ceiling so there's a bit of spare cable in the void/attic, though it's wise to plasterboard plug first."
"When using 10mm cable these are, by far, the most practical and safe switches to use. (With the square ones, there is not enough room to dress the cables and fix the switch to the pattress without using excessive forces which will lead to strain on the terminals and damage to the insulation). These allow the cable to be dressed tidily within the switch housing and make termination so much easier. Of the 30+ fitted over the last 5 years only one was faulty and none have gone wrong after fitting."
1 of 1 people found this review helpful.
Share this Review:
Review 10 for Crabtree 50A Pull Cord Switch + Neon
"a good isolating shower switch.it comes with its integral pattress,neon and mechanical green on/off indicator.it readily accepts up to 10mm cable,but you must ensure cables are aligned and stripped to correct length.have fitted quite a few of these and never had a call back"
Share this Review:
Review 17 for Crabtree 50A Pull Cord Switch + Neon